Power Management Datasheets

CH217K

WCH

USB port power distribution switch with adjustable current limit (400mA to 2.7A via external resistor), integrated overcurrent, overtemperature and undervoltage protection, 70mΩ on-resistance.

MX74610T

MaxLinear

Zero-Iq smart diode controller that drives an external N-channel MOSFET for reverse polarity protection and OR-ing, with a charge-pump gate driver and 2us reverse-polarity response

AP22653W6-7

Diodes Incorporated

LOAD SWITCH,SOT26,T&R,3K

DRV8833

Texas Instruments

Dual H-bridge current-control motor driver that can drive two DC motors or one stepper motor, with PWM winding current regulation and integrated fault protection.

DRV8876

Texas Instruments

N-channel H-bridge brushed DC motor driver with integrated current sensing, current regulation, proportional current output (IPROPI), and protection features, supporting 4.5 V to 37 V supply and 3.5 A peak output current.

MAX17048

Analog Devices

Tiny micropower single-cell Li+ fuel gauge using ModelGauge algorithm with no sense resistor, I2C interface, 3uA hibernate mode, and configurable alert output.

TB6612FNG

Toshiba

Dual H-bridge DC motor driver IC with low ON-resistance LD MOS output transistors, supporting CW/CCW/short brake/stop modes, standby, thermal shutdown and undervoltage detection

TL431

MSKSEMI Semiconductor

Three-terminal adjustable shunt regulator with ~2.5V reference, output settable up to 36V with two external resistors, 0.1mA to 100mA sink current

WRB0505S-3WR3H

unknown

3W, 2:1 wide input, isolated and regulated single-output DIP DC-DC converter with 5V nominal input and 5V/600mA output, 1500VDC isolation

A4988

Allegro MicroSystems

DMOS microstepping driver with built-in translator for bipolar stepper motors, supporting full to 1/16 step modes with up to 35 V and ±2 A output drive

ADE7953ACPZ-RL

Analog Devices

High accuracy single-phase multifunction energy metering IC with a second current input for neutral current measurement; measures active, reactive and apparent energy plus rms voltage and current, with SPI, I2C and UART interfaces.

ADG1434YCPZ-REEL

Analog Devices

Monolithic iCMOS quad SPDT analog switch with 4.7 Ω max on resistance, break-before-make action, and EN pin, specified for ±15 V/+12 V/±5 V supplies

ADG1434YRUZ-REEL7

Analog Devices

4 Ω RON quad SPDT (four independently selectable SPDT) iCMOS analog switch with break-before-make action, operating from ±15 V/+12 V/±5 V supplies

ADR4520

Analog Devices

2.048 V high-accuracy, low-power, ultralow-noise series voltage reference with ±0.02% initial error and up to 2 ppm/°C temperature coefficient

ADR4525

Analog Devices

Ultralow noise, high accuracy 2.5 V series voltage reference with low temperature drift (0.8 to 4 ppm/°C max) and 950 µA max quiescent current

ADR4525ARZ

Analog Devices

ADR4525BRZ

Analog Devices

Voltage References 2.5V Ultra Low Noise Voltage REF

ADR4525BRZ-R7

Analog Devices

ADR4525CRZ

Analog Devices

ADR4525CRZ-R7

Analog Devices

Voltage References 2.5V Ultra Low Noise Voltage REF

ADR4525D

Analog Devices

2.5 V high-accuracy, low-noise, low-power series voltage reference, D grade (0.8 ppm/°C max tempco, ±0.02% initial error) in an 8-lead LCC package

ADR4525DEZ

Analog Devices

ADR4525DEZ-R7

Analog Devices

ADR4525W

Analog Devices

AEC-Q100 qualified 2.5 V high accuracy, low noise, low power series voltage reference with 2 ppm/°C max temperature coefficient (B grade) and ±0.02% max initial error

ADR4525WBRZ-R7

Analog Devices

Voltage References 2.5V Ultra Low Noise Voltage REF

ADR4530

Analog Devices

3.0 V high-accuracy, low-noise, low-drift series voltage reference with ±0.02% initial error (B grade), 1 µV p-p noise and ±10 mA source/sink capability

ADR4533

Analog Devices

3.3 V high precision, low power, low noise series voltage reference with ±0.02% (B grade) initial accuracy and low temperature drift.

ADR4540

Analog Devices

4.096 V high accuracy, low power, ultralow noise series voltage reference with low temperature coefficient and low long-term drift

ADR4550

Analog Devices

High accuracy, low noise, low power 5 V series voltage reference with up to 0.8 ppm/°C temperature coefficient and ±0.02% initial error (B, C, D grades)

AP22653

Diodes Incorporated

Single-channel precision adjustable current-limited load switch with active-high enable, constant-current limiting during overcurrent, programmable limit 125mA to 2665mA via external resistor, and up to 2.1A continuous load current.