MKL25Z64VLH4

Part: MKL25Z128VLK4 — Freescale Type: ARM Cortex-M0+ Microcontroller Description: 48 MHz ARM Cortex-M0+ based microcontroller with up to 128 KB Flash and 16 KB SRAM, featuring USB 2.0, ultra low-power modes, and a wide range of communication and analog peripherals.

Operating Conditions:

• Supply voltage: 1.71 to 3.6 V
• Operating temperature: -40 to 105 °C
• Max CPU frequency: 48 MHz

Absolute Maximum Ratings:

• Max supply voltage: 3.8 V
• Max continuous current: 120 mA (Digital supply current)
• Max junction/storage temperature: 150 °C

Key Specs:

• Run mode current (48 MHz, CoreMark): 6.4 mA (Typ.)
• Run mode current (48 MHz, while(1)): 3.9 mA (Typ.), 4.8 mA (Max)
• Run power consumption (VLP run mode): 47 μA/MHz
• Static power consumption (full state retention): 2 μA
• Input leakage current (per pin, full temp range): 1 μA (Max)
• Input leakage current (per pin, 25 °C): 0.025 μA (Max)
• Internal pullup resistors: 20 to 50 kΩ
• Internal pulldown resistors: 20 to 50 kΩ

Features:

• Ultra-efficient Cortex-M0+ processor up to 48 MHz
• Up to 128 KB program flash memory and 16 KB SRAM
• Nine low-power modes
• USB full-/low-speed On-the-Go controller with on-chip transceiver
• Two 8-bit SPI modules, one low power UART, two UART modules, two I2C modules
• 16-bit SAR ADC, 12-bit DAC, Analog comparator
• Low-power hardware touch sensor interface (TSI)
• Up to 66 general-purpose input/output (GPIO)
• 80-bit unique identification number per chip

Applications:

• General purpose MCU with USB 2.0

Package:

• LQFP 80-pin

The following table shows the signals available on each pin and the locations of these pins on the devices supported by this document. The Port Control Module is responsible for selecting which ALT functionality is available on each pin.

Unless otherwise specified, propagation delays are measured from the 50% to the 50% point, and rise and fall times are measured at the 20% and 80% points, as shown in the following figure.

Figure 2. Input signal measurement reference

All digital I/O switching characteristics, unless otherwise specified, assume the output pins have the following characteristics.

• CL=30 pF loads
• Slew rate disabled
• Normal drive strength

Table 1. Thermal handling ratings

Package dimensions are provided in package drawings.

To find a package drawing, go to freescale.com and perform a keyword search for the drawing's document number: