MAX2769E/W
GNSS Receiver (Die)The MAX2769E/W is a gnss receiver (die) from Analog Devices. View the full MAX2769E/W datasheet below including key specifications, electrical characteristics, absolute maximum ratings.
MAX2769E/W shares its datasheet with MAX2769, whose page lists every part number it covers.
Official MAX2769E/W datasheet (PDF) — the source this page was extracted from.
MAX2769E/W Key Specifications
| Parameter | Value |
|---|---|
| ADC Output | 1 or 2 bits for I and Q, up to 3 bits for I |
| RF Frequency | 1575.42MHz (L1 band) |
| Supply Voltage | 2.7V to 3.3V |
| Image Rejection | 25dB |
| LNA1 Power Gain | 19dB |
| LNA2 Power Gain | 13dB |
| Shutdown Current | 20μA |
| Idle Mode Current | 1.5mA |
| LO Frequency Range | 1550MHz to 1610MHz |
| Cascaded Noise Figure | 1.4dB (LNA1 active) |
| Reference Input Frequency | 8MHz to 44MHz |
| Operating Temperature Range | -40°C to +85°C |
| Maximum Voltage Gain (Mixer To Baseband) | 91dB to 103dB (96dB typ) |
| Supply Current (LNA1 Active, Default Mode) | 15mA to 22mA (18mA typ) |
| Supply Current (LNA2 Active, Default Mode) | 12mA to 19mA (15mA typ) |
MAX2769E/W Overview
Part: MAX2769ETI+ — Maxim Integrated
Type: Universal GNSS Receiver RF Front-End
Description: Single-conversion, low-IF GNSS receiver covering GPS, GLONASS, and Galileo navigation satellite systems with integrated dual-input LNA, mixer, fractional-N synthesizer, monolithic filters, and multi-bit ADC.
Operating Conditions:
- Supply voltage: 2.7 to 3.3 V
- Operating temperature: -40 to +85 °C
- RF frequency: 1575.42 MHz (L1 band)
- Reference input frequency: 8 to 44 MHz
Absolute Maximum Ratings:
- Max supply voltage: 4.2 V (VCC to GND)
- Max continuous power dissipation: 2500 mW ( derates 27 mW/°C above +70 °C)
- Max junction/storage temperature: +150 °C
Key Specs:
- Cascaded noise figure: 1.4 dB (typ, LNA1 input active, default mode)
- Cascaded noise figure: 2.7 dB (typ, LNA2 input active, default mode)
- Supply current (default mode, LNA1 active): 18 mA (typ), 22 mA (max)
- Supply current (shutdown mode): 20 μA (typ, SHDN = low)
- LNA1 power gain: 19 dB (typ)
- LNA1 noise figure: 0.83 dB (typ)
- Maximum voltage gain (mixer to baseband analog output): 91 dB (min), 96 dB (typ), 103 dB (max)
- LO frequency range: 1550 to 1610 MHz (0.4 V < VTUNE < 2.4 V)
Features:
- Supports GPS, GLONASS, and Galileo navigation systems
- Integrated dual-input uncommitted LNA for passive and active antennas
- On-chip monolithic filter eliminates external IF SAW or discrete filters
- Fractional-N frequency synthesizer with integrated VCO
- Integrated multi-bit ADC outputting up to 3 quantized bits
- Integrated active antenna sensor and bias circuitry
- 3-wire serial interface for register configuration
Applications:
- Location-enabled mobile handsets
- Personal Navigation Devices (PNDs) and Personal Media Players (PMPs)
- In-vehicle navigation systems and telematics
- Software GPS receivers
- Laptops, ultra-mobile PCs, digital still cameras, and camcorders
Package:
- 28-pin Thin QFN-EP (5 mm x 5 mm)
- Dice (in wafer form)
MAX2769E/W Features
- ♦ GPS/GLONASS/Galileo Receivers
- ♦ No External IF SAW or Discrete Filters Required
- ♦ Programmable IF Frequency
- ♦ Fractional-N Synthesizer with Integrated VCO Supports Wide Range of Reference Frequencies
- ♦ Dual-Input Uncommitted LNA for Separate Passive and Active Antenna Inputs
- ♦ 1.4dB Cascade Noise Figure
- ♦ Integrated Crystal Oscillator
- ♦ Integrated Active Antenna Sensor
- ♦ 10mA Supply Current in Low-Power Mode
- ♦ 2.7V to 3.3V Supply Voltage
- ♦ Small, 28-Pin, RoHS-Compliant, Thin QFN LeadFree Package (5mm x 5mm)
MAX2769E/W Applications
Location-Enabled Mobile Handsets
PNDs (Personal Navigation Devices)
PMPs (Personal Media Players)
PDAs (Personal Digital Assistants)
In-Vehicle Navigation Systems
Telematics (Asset Tracking, Inventory Management)
Recreational/Marine Navigation/Avionics
Software GPS
Pin Configurations appear at end of data sheet. Laptops and Ultra-Mobile PCs
Functional Diagrams continued at end of data sheet. Digital Still Cameras and Camcorders
✵✣✳✰ ❉▲ ❁ ▼❒❁❄❅❍❁❒❋ ❏❆ ✭❁❘❉❍ ✩■▼❅❇❒❁▼❅❄ ✰❒❏❄◆❃▼▲✌ ✩■❃✎
MAX2769E/W Pin Configuration
)RU SULFLQJ GHOLYHU\ DQG RUGHULQJ LQIRUPDWLRQ SOHDVH FRQWDFW MD[LP 'LUHFW DW 629 6 2 RU YLVLW MD[LPV ZHEVLWH DW ZZZ PD[LP LQWHJUDWHG FRP
MAX2769E/W Electrical Characteristics
(MAX2769 EV kit, VCC = 2.7V to 3.3V, TA = -40 ° C to +85 ° C, PGM = GND. Registers are set to the default power-up states. Typical values are at VCC = 2.85V and TA = +25 ° C, unless otherwise noted.) (Note 1)
| PARAMETER | CONDITIONS | MIN | TYP | MAX | UNITS |
|---|---|---|---|---|---|
| Supply Voltage | 2.7 | 2.85 | 3.3 | V | |
| Supply Current | Default mode, LNA1 is active (Note 2) | 15 | 18 | 22 | mA |
| Supply Current | Default mode, LNA2 is active (Note 2) | 12 | 15 | 19 | mA |
| Supply Current | Idle Mode™, IDLE = low | 1.5 | 1.5 | 1.5 | mA |
| Supply Current | Shutdown mode, SHDN = low | 20 | 20 | 20 | μA |
| Voltage Drop at ANTBIAS from VCCRF | Sourcing 20mA at ANTBIAS | 0.2 | 0.2 | 0.2 | V |
| Short-Circuit Protection Current at ANTBIAS | ANTBIAS is shorted to ground | 57 | 57 | 57 | mA |
| Active Antenna Detection Current | To assert logic-high at ANTFLAG | 1.1 | 1.1 | 1.1 | mA |
| DIGITAL INPUT AND OUTPUT | DIGITAL INPUT AND OUTPUT | DIGITAL INPUT AND OUTPUT | DIGITAL INPUT AND OUTPUT | DIGITAL INPUT AND OUTPUT | DIGITAL INPUT AND OUTPUT |
| Digital Input Logic-High | Measure at the SHDN pin | 1.5 | 1.5 | 1.5 | V |
| Digital Input Logic-Low | Measure at the SHDN pin | 0.4 | 0.4 | 0.4 | V |
Idle Mode is a trademark of Maxim Integrated Products, Inc.
MAX2769E/W Absolute Maximum Ratings
| Parameter | Limit |
|---|---|
| V CC to GND | -0.3V to +4.2V |
| Other Pins to GND | -0.3V to +(Operating V CC + 0.3V) |
| Maximum RF Input Power | +15dBm |
| Continuous Power Dissipation (T A = +70 ° C) 28-Pin Thin QFN (derates 27mW/ ° C above +70 ° C)...2500mW |
| Parameter | Limit |
|---|---|
| Operating Temperature Range | -40 ° C to +85 ° C |
| Junction Temperature | +150 ° C |
| Storage Temperature Range | -65 ° C to +150 ° C |
| Lead Temperature (TQFN only, soldering, 10s) | +300 ° C |
| Soldering Temperature (reflow) | +260°C |
Stresses beyond those listed under 'Absolute Maximum Ratings' may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
MAX2769E/W Typical Application
Table 1. Component List
| DESIGNATION | QUANTITY | DESCRIPTION |
|---|---|---|
| C0 | 1 | 0.47nF AC-coupling capacitor |
| C1 | 1 | 27pF PLL loop filter capacitor |
| C2 | 1 | 0.47nF PLL loop filter capacitor |
| C3-C8 | 6 | 0.1μF supply voltage bypass capacitor |
| C10, C11 | 2 | 10nF AC-coupling capacitor |
| C12 | 1 | 0.47nF AC-coupling capacitor |
| C13 | 1 | 0.1nF supply voltage bypass capacitor |
| R1 | 1 | 20k Ω PLL loop filter resistor |
MAX2769E/W Package Information
For the latest package outline information and land patterns, go to www.maxim-ic.com/packages .
| PACKAGE TYPE | PACKAGE CODE | DOCUMENT NO. |
|---|---|---|
| 28 TQFN-EP | T2855+3 | 21-0140 |
| WAFER | WDICE8 | - |
Variants on the same datasheet
These parts have exact links to the same datasheet. They are candidates to compare, not verified drop-in replacements; check package, pinout and electrical limits.
| Part Number | Manufacturer | Package |
|---|---|---|
| MAX2769 | Analog Devices | 28 Thin QFN-EP |
| MAX2769ETI | Analog Devices | TQFN-28-EP 5x5mm |
| MAX2769ETI+ | Analog Devices | 28-WFQFN Exposed Pad |
| MAX2769EW | Analog Devices | Die |
Other RF / Wireless
- ST25DV04KC-IE6S3 – STMicroelectronics, Dynamic NFC/RFID Tag IC
- SX1276 – Semtech, Low Power Long Range Transceiver
- XA2214-S14 – Xinluda Information Technology Co., Ltd, GaAs MMIC SPDT Switch
- CC1101 – Texas Instruments, RF Transceiver
- EG915UEUAC-N05-SNNSA – Quectel, LTE Cat 1 Cellular Module
- ESP32-S3 – Espressif Systems, Wireless SoC
- SMTSO2515CTJ – Sinhoo, Surface Mount Nut
- ESP32-WROOM-32 – Espressif Systems, Wi-Fi+BT+BLE MCU module
All RF / Wireless datasheetsAll Analog Devices datasheets (700)
Ask your AI agent about the MAX2769E/W
Connect SheetsData to Claude, Cursor, Codex or any MCP client and your agent reads this datasheet for you: pinout, limits, register maps and design checks, with the numbers taken from the PDF.
claude mcp add --transport http sheetsdata https://mcp.sheetsdata.com/mcp
Then ask: "Can the MAX2769E/W run from my 12 V rail? Check it against the datasheet limits."
Create a free account $2 of usage every month, no card needed.