Part: WT series

Type: Aluminum Electrolytic Capacitor, Chip Type

Description: Chip type aluminum electrolytic capacitors operating over a wide temperature range of -55 to +105°C, with a rated voltage range of 4 to 50V and capacitance from 0.1 to 1500μF.

Operating Conditions:

• Supply voltage: 4 to 50V
• Operating temperature: -55 to +105°C
• Capacitance range: 0.1 to 1500μF

Absolute Maximum Ratings:

• Max supply voltage: 50 V
• Max junction/storage temperature: 105 °C

Key Specs:

• Category Temperature Range: -55 to +105°C
• Rated Voltage Range: 4 to 50V
• Rated Capacitance Range: 0.1 to 1500μF
• Capacitance Tolerance: ±20% at 120Hz, 20°C
• Leakage Current: Not more than 0.01CV or 3 μA (whichever is greater, after 2 minutes' application of rated voltage)
• Tangent of loss angle (tan δ) Max: 0.40 (at 4V) to 0.14 (at 50V)
• Endurance: Capacitance change within ±25% (for φ 3mm, 16V) or ±20% (for 25V or more), tan δ 200% or less, leakage current less than or equal to initial specified value (after rated voltage applied for 1000 hours at 105°C).
• Shelf Life: Meets endurance characteristics after storing at 105°C for 1000 hours (no load) and voltage treatment.

Features:

• Chip type operating over wide temperature range of -55 to +105°C
• Designed for surface mounting on high density PC board
• Applicable to automatic mounting machine fed with carrier tape
• Compliant to the RoHS directive (2002/95/EC)

Applications:

• Not specified

Package:

• 3 × 5.4 mm
• 4 × 5.4 mm
• 5 × 5.4 mm
• 6.3 × 5.4 mm
• 6.3 × 5.8 mm
• 6.3 × 7.7 mm
• 8 × 5.4 mm
• 8 × 10 mm
• 10 × 10 mm

UWT1H101MNL1GS Pinout

Package: 3×5.4mm Chip Type (2-pin SMD Aluminum Electrolytic Capacitor)

Notes

• UWT1H101MNL1GS is a 100 µF, 10V aluminum electrolytic capacitor in a 3×5.4mm chip package.
• This is a passive two-terminal component (capacitor), not an active IC. Pin designations refer to the cathode and anode terminals.
• Operating temperature range: −55 to +105°C.
• The part number decoding: WT (series) + 1H (10V) + 101 (100 µF) + MNL1GS (packaging/tape specifications).
• Polarity must be observed during installation; the cathode (negative) terminal is typically marked on the component body.