MAX-M10S-00B-01

Part: MAX-M10S-00B-01 — u-blox Type: Standard precision GNSS module Description: Ultra-low-power GNSS receiver for high-performance asset-tracking applications, supporting concurrent reception of four GNSS constellations (GPS, GLONASS, Galileo, BeiDou) with 25 mW power consumption in continuous tracking mode.

Operating Conditions:

• Operating temperature: -40 to +85 °C
• Max navigation update rate: Up to 25 Hz (single GNSS), 20 Hz (multi-constellation)
• Position accuracy (CEP): 1.5 m (GPS+GAL+BDSB1I default)

Absolute Maximum Ratings:

• Max main supply voltage (VCC): 3.6 V
• Max IO supply voltage (V_IO): VCC+0.3 V (max 3.6 V)
• Max backup supply voltage (V_BCKP): 3.6 V
• Max source / sink current, digital pins (I_PIO): 10 mA
• Max RF input power on RF_IN (P rfin): 0 dBm
• Max ambient temperature (T amb): +85 °C
• Max storage temperature (T s): +85 °C

Key Specs:

• Receiver type: u-blox M10 receiver
• Power consumption (continuous tracking): 25 mW
• Time pulse signal accuracy (RMS 99%): 30 ns
• Velocity accuracy: 0.05 m/s
• Dynamic heading accuracy: 0.3 deg
• Sensitivity (Tracking and nav.): -167 dBm (GPS+GAL)
• Cold start TTFF: 27 s (GPS+GAL+BDSB1I default)
• Hot start TTFF: 1 s

Features:

• Concurrent reception of four GNSS (GPS, GLONASS, Galileo, BeiDou)
• u-blox Super-S (Super-Signal) technology for improved RF sensitivity
• Integrated LNA and SAW filter for passive antenna designs
• Backwards pin-to-pin compatibility with previous u-blox generations
• Antenna supervisor for active antenna control and short detection
• CloudLocateGNSS for energy-constrained IoT applications
• Assisted GNSS (AssistNow Online, Offline, Autonomous)
• Power save modes (On/off, cyclic tracking)
• Anti-jamming and anti-spoofing
• Secure boot and message integrity

Applications:

• High-performance asset-tracking applications
• Battery-operated devices

Package:

• 18-pin module

Figure 2: MAX-M10S pin assignment

Figure 2: MAX-M10S pin assignment

CAUTION Operating the device above one or more of the limiting values may cause permanent damage to the device. The values provided in this chapter are stress ratings. Extended exposure to the values outside the limits may effect the device reliability.

• Where application information is given, it is advisory only and does not form part of the specification.

Table 12: Absolute maximum ratings

V_IO supply voltage must not be higher than VCC + 0.3 V.

The product is not protected against overvoltage or reversed voltages. Voltage spikes exceeding the power supply voltage specification, given in the table above, must be limited to values within the specified boundaries by using appropriate protection diodes.