MAX-M10M-00B-01

Part: MAX-M10M-00B-01 — u-blox Type: Standard precision GNSS module Description: Ultra-low-power GNSS receiver for high-performance asset-tracking applications, supporting concurrent reception of four GNSS constellations (GPS, GLONASS, Galileo, BeiDou) with less than 10 mW power consumption in cyclic tracking power save mode.

Operating Conditions:

• Supply voltage: 1.76–5.5 V (VCC), 1.68–1.98 V (V_IO with VIO_SEL=GND)
• Operating temperature: -40 to +85 °C
• Max navigation update rate: 20 Hz (GPS+GAL, high performance)
• Position accuracy (CEP): 1.5 m (GPS+GAL)

Absolute Maximum Ratings:

• Max supply voltage (VCC): 6 V
• Max IO supply voltage (V_IO): 3.6 V
• Max source / sink current, digital pins: 10 mA
• Max RF input power on RF_IN: +15 dBm
• Max ambient temperature: +85 °C
• Max storage temperature: +85 °C

Key Specs:

• Receiver type: u-blox M10 receiver
• Power consumption: < 10 mW (1 Hz cyclic tracking power save mode)
• Velocity accuracy: 0.05 m/s
• Dynamic heading accuracy: 0.3 deg
• Time To First Fix (TTFF) Cold start: 23 s (GPS+GAL+GLO)
• Time To First Fix (TTFF) Hot start: 1 s
• Sensitivity (Tracking and nav.): -167 dBm (GPS+GAL+GLO)
• Supported GNSS: GPS, GLONASS, Galileo, BeiDou (concurrent reception of four)

Features:

• Ultra-low-power consumption
• Concurrent reception of four GNSS constellations
• u-blox Super-S (Super-Signal) technology for improved RF sensitivity
• Backwards pin-to-pin compatibility with previous u-blox generations
• Antenna supervisor for active antenna control and short detection
• CloudLocate GNSS for energy-constrained IoT applications
• Assisted GNSS (AssistNow Online, Offline, Autonomous)
• Power save modes (On/off, cyclic tracking)
• Anti-jamming and anti-spoofing
• Secure boot and message integrity

Applications:

• High-performance asset-tracking applications

Package:

• 18-pin module

Table 9: Security features

Figure 2: MAX-M10M pin assignment

Figure 2: MAX-M10M pin assignment

CAUTION Operating the device above one or more of the limiting values may cause permanent damage to the device. The values provided in this chapter are stress ratings. Extended exposure to the values outside the limits may effect the device reliability.

• Where application information is given, it is advisory only and does not form part of the specification.

Table 12: Absolute maximum ratings

The product is not protected against overvoltage or reversed voltages. Voltage spikes exceeding the power supply voltage specification, given in the table above, must be limited to values within the specified boundaries by using appropriate protection diodes.