M24C02-DRMF3TG/K

Part: M24C02-A125 from STMicroelectronics

Type: Automotive 2-Kbit serial I²C bus EEPROM

Key Specs:

• Memory Size: 2 Kbits (256 bytes)
• Max I2C Clock Frequency: 1 MHz
• Operating Temperature Range: -40 °C to 125 °C
• Supply Voltage Range: 1.7 V to 5.5 V
• Write Cycle Time (Byte/Page): 4 ms
• Data Retention: 50 years at 125 °C
• ESD Protection (HBM): 4000 V

Features:

• Compatible with all I2C bus modes (1 MHz, 400 kHz, 100 kHz)
• 16-byte page size
• Additional write lockable identification page
• Schmitt trigger inputs for noise filtering
• Write cycle endurance: 4 million at 25 °C, 1.2 million at 85 °C, 600 k at 125 °C
• RoHS compliant and halogen-free (ECOPACK2) packages
• Automotive grade, compliant with AEC-Q100 grade 1
• Byte-alterable memory (256 × 8 bits)
• Embedded error correction code logic

Applications:

• Automotive applications

Package:

• TSSOP8 (DW): 169 mil width
• SO8N (MN): 150 mil width
• WFDFPN8 (MF): DFN8 - 2 x 3 mm

• Compatible with all I2C bus modes
  • 1 MHz
  • 400 kHz
  • 100 kHz
• Memory array
  • 2 Kbits (256 bytes) of EEPROM
  • Page size: 16 bytes
  • Additional write lockable page (identification page)
• Extended temperature and voltage ranges
  • -40 °C to 125 °C; 1.7 V to 5.5 V
• Schmitt trigger inputs for noise filtering
• Short write cycle time
  • Byte write within 4 ms
  • Page write within 4 ms
• Write cycle endurance
  • 4 million write cycles at 25 °C
  • 1.2 million write cycles at 85 °C
  • 600 k write cycles at 125 °C
• Data retention
  • 50 years at 125 °C
  • 100 years at 25 °C
  • ESD Protection (human body model)
    • 4000 V
  • Packages
    • RoHS compliant and halogen-free (ECOPACK2)

1. The device is not selected after power-up, after a read instruction (after the stop condition), or after the completion of the internal write cycle tW (tW is triggered by the correct decoding of a write instruction).

2. Ei inputs should be tied to Vss (see Section 2.3: Chip enable (E2, E1, E0)).

3. Ei inputs should be tied to VCC (see Section 2.3: Chip enable (E2, E1, E0)).

4. Evaluated by characterization, not tested in production.

1. Compliant with JEDEC Std J-STD-020 (for small body, Sn-Pb or Pb-free assembly), the ST ECOPACK® 7191395 specification, and the European directive on Restrictions on Hazardous Substances (RoHS directive 2011/65/EU of July 2011).

2. Positive and negative pulses applied on pin pairs, according to AEC-Q100-002 (compliant with ANSI/ESDA/JEDEC JS-001, C1=100 pF, R1=1500 Ω, R2=500 Ω).