GRM31CR71E106KA12L

Part: GRM31CR71E106KA12_ — Murata Type: Chip Monolithic Ceramic Capacitor Description: A 10 μF, DC 25 V, X7R dielectric chip monolithic ceramic capacitor with ±10% tolerance, designed for general electronic equipment.

Operating Conditions:

• Operating temperature: -55 to 125 °C
• Rated voltage: DC 25 V

Absolute Maximum Ratings:

• Max applied voltage: 250% of rated voltage (for voltage proof test)

Key Specs:

• Nominal Capacitance: 10 μF
• Capacitance Tolerance: ±10%
• Temperature Characteristics: X7R (EIA)
• Temperature Coefficient Capacitance Change: -15 to 15% (-55 to 125 °C)
• Insulation Resistance (I.R.): More than 2000 MΩ or 50 Ω∙F (whichever is smaller) at DC Rated Voltage
• Dissipation Factor (D.F.): 0.125 max (for GRM31CR71E106)
• Capacitance Measurement Frequency: 120±24 Hz (for C > 10 μF)
• Capacitance Measurement Voltage: 0.5±0.1 Vrms (for C > 10 μF)

Features:

• X7R dielectric for stable capacitance over temperature
• Available in embossed tape packaging (φ180mm and φ330mm reels)
• Suitable for reflow soldering

Applications:

• General Electronic equipment

Package:

• 1206 (3.2±0.2 mm L x 1.6±0.2 mm W x 1.6±0.2 mm T)

Please contact us before using our products for the applications listed below which require especially high reliability for the prevention of defects which might directly cause damage to the third party's life, body or property.

• [1] Aircraft equipment [2] Aerospace equipment [3] Undersea equipment [4] Power plant control equipment
• [5] Medical equipment [6] Transportation equipment(vehicles,trains,ships,etc.) [7] Traffic signal equipment
• [8]
• Disaster prevention / crime prevention equipment [9] Data-processing equipment
• [10] Application of similar complexity and/or reliability requirements to the applications listed in the above.

GRM31CR71E106KA12L — 1206 (3216 Metric) Chip Monolithic Ceramic Capacitor

Pinout

Notes

• Package: 1206 (3216 Metric) — a two-terminal surface-mount ceramic capacitor with no internal pins or leads.
• Specifications: 10 μF, DC 25V, X7R dielectric, ±10% tolerance.
• Terminations: Both terminations are solder-plated outer electrodes on the chip ends. Pin numbering follows standard PCB land convention (left to right when viewing the component).
• No pin diagram was provided in the source material; pin numbering is based on standard 1206 SMD orientation (Pin 1 = left termination, Pin 2 = right termination).